 Click here to return to the Prowler Online Board Main Page |
 ProwlerOnline, Plymouth/Chrysler Prowler Discussion Forum
 General Prowler Discussion
 " Newbies to POA " Dont be alarmed..............
|
| Bottom of Page | next newest topic | next oldest topic |
| Author | Topic: " Newbies to POA " Dont be alarmed.............. |
thedqman POA Site Supporter Prowler Junkie From:Marco Island Fl |
posted 09-02-2007 10:25 AM
    
IF....... 1. Your wheels start to peel or bubble 2. Your front speakers blow out 3. Your ball joints need to be replaced 4. Your hood props fall on your head 5. Your gas tank seal starts to leak 6. Your window regulators stop going up or down 7. Your front shocks leak 8. Your conv top lets more water in than it keeps out 9. Your low tire light will not go off 10. Your Tanny sensors put you in Limp mode 11. You'll have to do The Hot Glue technique to the wheel center caps We still have the most *****unique*** car on the road TODAY ! This message has been edited by thedqman on 09-02-2007 at 02:29 PM |
Marty Usher         POA Site Supporter Prowler Junkie From:San Antonio, Texas, United States |
posted 09-02-2007 10:28 AM
I hope all that didn't happen to you during your first few cruises in your flamed kat!!  |
|
thedqman POA Site Supporter Prowler Junkie From:Marco Island Fl |
posted 09-02-2007 10:31 AM
No the Flamed kat is actually the only one I HAVENT expierienced any problems with.... They must have all been taken care of By Tom, Car runs PERRRRRRFECT! |
Northern Cat POA Site Supporter Prowler Junkie From:Stoney Creek, Ontario, Canada |
posted 09-02-2007 10:35 AM
That's needs to be a T-Shirt for Newbies...kinda like the one for the Top 10 questions asked about the Prowler |
binster POA Site Supporter Prowler Junkie From:cary, north carolina, usa |
posted 09-02-2007 01:15 PM
Ya forgot bubbling paint.. From a newbie.... |
|
thedqman POA Site Supporter Prowler Junkie From:Marco Island Fl |
posted 09-02-2007 02:27 PM
binster, A few years back, at Prowlin the Smokies, we saw many Kats that had that problem, but it seemed to be only around the trunk area near the bottom lip and around the hinges. Maybe we should add that to the list ! |
|
binster POA Site Supporter Prowler Junkie From:cary, north carolina, usa |
posted 09-02-2007 03:20 PM
Yep.. I have two spots.. one near passenger door handle, other on corner of side panel.. So, How about a rebuttal for the the Prowler oldies " All in good fun"
|
|
pjr300 Prowler Newbie From:Northville MI |
posted 09-09-2007 08:27 AM
Great post folks. I am also a newB and hope to purchase a Kat in the near future. I'll remember this post when I go checking out the potential vehicles! P.S. Checking out one tomorrow! This message has been edited by pjr300 on 09-09-2007 at 08:40 AM |
392HEMI POA Site Supporter Prowler Junkie From:The Villages, Fl. |
posted 09-10-2007 01:06 PM
Mike, you left out the most popular problem. 1.) Your nose WILL NOT FIT over a curb!!!!! |
catfish        POA Site Supporter Prowler Junkie From:scottsdale,az,usa |
posted 09-10-2007 07:40 PM
wiring problems and dieing and fuel pump problems-still a great car made in america. ------------------ |
|
lavka POA Site Supporter Prowler Junkie From:Marble Falls, Texas |
posted 09-12-2007 01:07 PM
Here's a few more: 13) The "factory engineered" front splash guards need to be trimmed an inch (or more) to keep you from pulling the front fender off when you back the car up. 14) You tap the curb with your right front tire while doing a U-turn at 5 miles an hour and do $30K plus in damage to the car. It stays in the shop for months to be fixed. ( Did not happen to me fortunatly but a fellow POA member) This message has been edited by lavka on 09-12-2007 at 04:15 PM |
All times are CT (US) Top of Page Previous Page | Return to General Prowler Discussion next newest topic | next oldest topic |
  |
|
Contact Us | Prowler Online Homepage
All material contained herein, Copyright 2000 - 2012 ProwlerOnline.com
E-Innovations, LP
