Author	Topic:   Failing ball joint update............
Kozican Prowler Junkie Posts: 802 From: HOUSTON,TEXAS Registered: DEC 2000	posted 04-04-2001 05:34 PM          Stopped by the dealer today. Not much going on yet. The advisor did tell me the knuckle was in. I questioned about the knuckle being replaced in the first place. The tech told him that anytime you replace a lower control arm you need to replace the knuckle? I've been fixing wrecked cars for 17 yrs now and that was a first! I hope a rep shows up to look at this thing soon! I feel like its at the "shade tree's garage" So far there is a rack-n-pinion and a knuckle here. They are still waiting on a lower control arm and wheel. And who knows what else they've ordered? I'll try and give another update when I hopefully hear from DC or its DONE!
neal Prowler Junkie Posts: 159 From: dallas,tex. u.s.a. Registered: OCT 2000	posted 04-04-2001 06:14 PM          I am a Prowler tech in the Dallas area. We have not really experienced any front end failure yet. After all repairs are done , I would think a front end alignment would be nessary.Make sure they give you a computer print out of all specs. Before a alignment can be done Ride height need to be measured. The cat is low to the ground. IF ride height is not in specs this must be corrected before alignment is done. Hope this helps Neal

All material contained herein, Copyright 2000 - 2012 ProwlerOnline.com
E-Innovations, LP

POA Terms of Service

Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45c