Archive: control arm damage - ProwlerOnline, Plymouth/Chrysler Prowler Discussion Forum

Note: This is an archived topic. It is read-only.

control arm damage

This topic was originally posted in this forum: Political Off Topic

Author	Topic: control arm damage
bruce hazelton Prowler Junkie Posts: 299 From: burlington,wi 53105 Registered: DEC 2001	posted 05-28-2003 12:39 PM Just did our first recall at our dealership and are now waiting for a new lower control arm. Let your Prowler tech know to pull out the large wire snap ring from the old ball joint boot before pressing it out. Our 20plus year tech followed the directions exactly but the snap ring went into the arm with the tool. Stuck real good!! The directions don't mention this but a little heads up may prevent another disaster.
DAVE FERRARO unregistered Posts: 299 From: burlington,wi 53105 Registered: DEC 2001	posted 05-28-2003 03:21 PM This has been discussed several times on this site. Removing the ring makes all of the difference in doing the job right.

All times are CT (US)	This is an ARCHIVED topic. You may not reply to it!

	Hop to:

Contact Us | Prowler Online Homepage

All material contained herein, Copyright 2000 - 2012 ProwlerOnline.com
E-Innovations, LP