Home Page | Owners Registry | Discussion Forums | ProwlerMall | Event Scrapbooks | About |
Click here to return to the Prowler Online Board Main Page Topic Closed |
ProwlerOnline, Plymouth/Chrysler Prowler Discussion Forum
General Prowler Discussion MTD Prowler Intake System 2.2
|
Bottom of Page | next newest topic | next oldest topic |
Author | Topic: MTD Prowler Intake System 2.2 |
MichealSwan Prowler Newbie From:Raleigh, NC 27529 |
posted 06-14-2002 07:46 PM
GAWD DAMN!!!! Just installed the Prowler Intake System 2.2 by Magic Touch Designs. I was using the regular flat K&N replacement air filter. I noticed a little difference when I changed from the paper filter to it. But after installing the MTD 2.2, I am wishing I wopuld have went with it a long time ago. Why did I hold out??? Only took about 20 minutes to install. And after starting the engine, you could hear a small difference when just idling... But when I stepped on the gas (while in park), good lord, it jumps up to 5,000 RPMs so much quicker. Then I put it in drive and step on the gas a little bit... Chripped the tires in my driveway... And I was not trying to. LOL Then just driving around town, man, I could tell a big difference. I am real impressed with Bill's work. The heat sheild is a little flimsy and popped off a few times while installing it, but I noticed if you push a 1/4 inch back off the Filter (So it is not sitting flush at the back), it fits a bit tighter. I guess because the center part of the clamp is on the ring of the filter. I will have to check it to make sure it does not slip off... :-) Thanks a lot Bill. And the Bypass Kit is easy too, about 2 minutes work... lol My only question is, when does the MTD Street Tuned Exhaust come out??? I know it will be the perfect match for the Intake System. Put me down for one Bill. |
WPG Prowler Junkie From:Orlando, Florida |
posted 06-16-2002 09:09 AM
- This message has been edited by William Gallagher on 03-10-2004 at 05:20 PM |
WPG Prowler Junkie From:Orlando, Florida |
posted 06-18-2002 06:27 PM
- This message has been edited by William Gallagher on 03-10-2004 at 05:20 PM |
Rich C Prowler Enthusiast From:huntington beach, ca. usa |
posted 06-18-2002 06:33 PM
where do you get the pricing and shipping info on this intake system? |
ALLEY CAT POA Lifetime Site Supporter Prowler Junkie From:mesa, az, USA |
posted 06-18-2002 07:24 PM
Rich - right above you,,,,,,William Gallagher's post,,,,,click on his email address and write him. Bill is MagicTouchDesigns (MTD) His products carry the Alley Cat Stamp of Approval ------------------ This message has been edited by ALLEY CAT on 06-18-2002 at 07:25 PM |
BLACKAL POA Site Supporter Prowler Junkie From:BELFAIR,WA USA |
posted 06-18-2002 08:16 PM
My intake system arrived today. Will install it tomorrow. Can't wait to see how it works. Al ------------------ |
All times are CT (US) Top of Page Previous Page | Return to General Prowler Discussion next newest topic | next oldest topic |
All material contained herein, Copyright 2000 - 2012 ProwlerOnline.com
E-Innovations, LP